Printer Service Mode
SM Appendices
3-423 D0CA/D0C9/D0C8/D0CB
SP Mode Tables
1001 Bit Switch
on the model.
bit
5
Direction of Output Face-down Face-up
This setting enables you to specify the whether the paper is output face-down or
face-up onto the output tray.
bit
6
Change Imposition
Specification
Standard specification Old model
specification
This setting enables the specification for imposition such as page alignment and
image rotation to be changed to the specification of old models when job orientation
and paper size are mixed.
The old models are below:
- PCL: 04A and earlier models
- PS/PDF/RPCS: 05S and earlier models
- BMLinkS: 05A and earlier models
IRIPS PS/PDF:
- 09A and earlier models: Operation under current model specification is not
supported (Operation with older specification is recommended)
- 15S and later models: Operation under current model specification is supported.
bit
7
Paper Path for Letterhead
Simplex Job
Simplex paper path Duplex paper path
This setting enables the simplex job to be routed through the duplex unit. Only affects
jobs specified as letterhead.
1001 Bit Switch
006 Bit Switch 6 0 1
bit 0 Forced printing Disabled Enabled
If enabled, the image will be printed regardless of whether the specified roller is of
the correct size paper or not. This is similar to "Form Feed" on a standard printer.
The default is disabled.
Include bypass in auto tray select Disable Enable
If enabled, the Bypass tray will be included in auto
tray selection.
bit 1
to 7
DFU - -
1001 Bit Switch
007 Bit Switch 7 0 1
bit 0 to 7 DFU - -
To Next Page
Loading...
