Printer Service Mode
SM Appendices
3-427 D0CA/D0C9/D0C8/D0CB
SP Mode Tables
1001 Bit Switch
out of paper, printing will occur from the Bypass Tray.
Disabled (=1):
Limitless Paper Feeding is not applied to the Bypass Tray.
If a tray other than the Bypass Tray matches the job's paper size and type but has run
out of paper, printing will stop and an alert will appear on the LCD screen, stating that
the tray has run out of paper. This prevents unexpected use of the Bypass Tray.
Limitations when this BitSw is set to "1":
- Jobs that contain more than one paper size cannot be printed.
-
The "Paper Tray Priority: Printer" setting must be configured to a tray other than the
Bypass Tray.
bit
3
DFU - -
bit
4
"Apply Auto Paper Select" to
Override Paper Size or Paper Type of the
Device
Disabled Enabled
If this BitSw is enabled, the "Apply Auto Paper Select" setting will decide if the paper
size or paper type that is specified in the device settings should be overridden by the
job's commands when "Tray Setting Priority" is set to "Driver/Command" or "Machine
Setting(s): Any Type".
- Apply Auto Paper Select = OFF: Overridden (priority is given to the job’s
commands)
- Apply Auto Paper Select = ON: NOT overridden (priority is given to the device
settings)
bit
5
Not Used - -
bit
6
Tray Selection when a Paper Mismatch
Occurs.
Disabled Enabled
This BitSw enables the inactive auto paper select tray to be unselectable when a
paper size/type mismatch occurs.
bit
7
Not Used
1001 Bit Switch
012
Bit Switch C 0 1
bit 0
to 2
DFU - -
bit 3 Switching paper discharge operation when the
limit number of sheets stapled is exceeded
one by one Upper limit
number
To Next Page
Loading...
