Ricoh IM C300 - Page 1496

Error Codes
SM 21 D0CK
Code Meaning Suggested Cause/Action
Cross reference
• See error code 0-04.
0-06 The other terminal did not reply to
DCS
• Check the line connection.
• Try adjusting the TX level and/or cable
equalizer settings.
• Replace the FCU (PCB2).
• The other end may be defective or
incompatible; try sending to another machine.
• Check for line problems.
Cross reference
• See error code 0-04.
0-07 No post-message response from the
other end after a page was sent
• Check the line connection.
• Replace the FCU (PCB2).
• The other end may have jammed or run out of
paper.
• The other end user may have disconnected the
call.
• Check for a bad line.
• The other end may be defective; try sending to
another machine.
0-08 The other end sent RTN or PIN after
receiving a page, because there were
too many errors
• Check the line connection.
• Replace the FCU (PCB2).
• The other end may have jammed, or run out of
paper or memory space.
• Try adjusting the TX level and/or cable
equalizer settings.
• The other end may have a defective
modem/FCU (PCB2); try sending to another
machine.
• Check for line problems and noise.
Cross reference
• TX level - NCU Parameter 01 (PSTN)
• Cable equalizer - G3 Switch 07 (PSTN)
• Dedicated TX parameters in Service Program
Mode
0-14 Non-standard post message response
code received
• Incompatible or defective remote terminal; try
sending to another machine.