Bit Switches – 1
SM 63 D0CK
Otherwise, keep this bit at "1 (default setting)".
5-
7
Not used Do not change the settings
* This setting can be used for the client machine which has no FCU.
System Switch 1F (SP No. 1-101-032)
No Function Comments
0 Trace log function
0: Enable
1: Disable
1 Report printout after an original jam
during SAF storage or if the SAF
memory fills up
0: Enabled
1: Disabled
0: When an original jams, or the SAF memory
overflows during scanning, a report will be printed.
Change this bit to "1" if the customer does not want to
have a report in these cases.
Memory tx – Memory storage report
Parallel memory tx – Transmission result report
2 Not used Do not change the settings.
3 Received fax print start timing
(G3 reception)
0: After receiving each page
1: After receiving all pages
0: The machine prints each page immediately after the
machine receives it.
1: The machine prints the complete message after the
machine receives all the pages in the memory.
4-
6
Not used Do not change the factory settings.
7 Action when a fax SC has occurred
0: Automatic reset
1: Fax unit stops
0: When the fax unit detects a fax SC code other than
SC1201 and SC1207, the fax unit automatically resets
itself.
1: When the fax unit detects any fax SC code, the fax
unit stops.
Cross Reference
Fax SC codes - See "Troubleshooting"
To Next Page
Loading...
