Bit Switches – 2
D0CK 74 SM
4 reports even if page separation occurs.
User Parameter Switch 19 (13H) bit 4 must be set to "0" to
enable this switch.
Refer to Detailed Section Descriptions for more on this
feature.
Bit
4
Bit
3
Setting
0 0 The upper half
only
0 1 50% reduction
(sub-scan only)
1 0 Same size
1 1 Not used
5-
6
Not used Do not change the settings.
7 Equalizing the reduction ratio
among separated pages
(Page Separation)
0: Enabled
1: Disabled
0: When page separation has taken place, all the pages are
reduced with the same reduction ratio.
1: Only the last page is reduced to fit the selected paper size
when page separation has taken place. Other pages are
printed without reduction.
* This setting can be used for the client-side machine which has no FCU.
Printer Switch 0F (SP No. 1-103-016)
No Function Comments
0-
1*
Smoothing feature (0, 0) (0, 1): Disable smoothing if the machine receives halftone
images from other manufacturers fax machines frequently.
Bit 1 Bit 0 Setting
0 0 Disabled
0 1 Disabled
1 0 Enabled
1 1 Not used
2* Duplex printing
0: Disabled
1: Enabled
1: The machine always prints received fax messages in duplex
printing mode:
3 Binding direction for
Duplex printing
0: Left binding
1: Top binding
0: Sets the binding for the left edge of the stack.
1: Sets the binding for the top of the stack.
4-7 Not used Do not change the settings.
* This setting can be used for the client-side machine which has no FCU.
To Next Page
Loading...
