Dehumidification Heater (main unit)
SM 2-121 D0CA/D0C9/D0C8/D0CB
3. Pull out the waste toner bottle [A]
4. Pull out the paper tray.
5. Connect the connector of the junction harness to CN600 [A] on the PSU (PCB17).
6. Connect the connector of the junction harness to the bracket [B].
7. Route the junction harness in the red dotted line in the photo.
• A: For anti-condensation heater (H1)
• B:Not used (For the Locker switch)
• C: For the heater harness
• D:For the PSU (PCB17) (CN600)
To Next Page
Loading...
