PM/Yield Parts Settings
SM 3-3 D0CA/D0C9/D0C8/D0CB
3.Press [EXECUTE] to output the PM counter list.
4. Press [Exit].
3. In the SMC data, check the values of the counters in SP7-621-002 to 208, to determine
what parts should be replaced. (Refer to the SP table in the appendix.)
4. Set the following SPs (New Unit Detection) to "1" to reset the PM counter.
Item SP
Fusing sleeve belt assembly SP3-701-116
Pressure roller SP3-701-118
ITB unit SP3-701-093
Paper transfer roller unit SP3-701-109
Waste toner bottle
(When the bottle is replaced BEFORE a waste toner full or
near-full message appears)
SP3-701-142
ADF Friction pad: SP3-701-206
Pickup roller: SP3-701-207
Feed roller: SP3-701-208
Paper feed tray (Tray 1) For A Feed roller: SP3-701-147
Friction pad: SP3-701-148
Paper feed tray (Tray 1) for B/Bf Pick-up roller:
SP3-701-158
Feed roller: SP3-701-159
To Next Page
Loading...
