D0CA/D0C9/D0C8/D0CB xxiii SM
MultiTouch Calibration ........................................................................................... 8-45
eMMC Erasure Count ............................................................................................ 8-45
MultiTouch Sensitivity Adjustment ......................................................................... 8-46
If the sensitivity level is set to "0", the MultiTouch function is turned off and you
cannot pinch in or out. ........................................................................................... 8-46
Press [Detect level confirmation]........................................................................... 8-46
8.3.5 RECOVERY MODE ........................................................................................... 8-48
8.3.6 SPECIAL KEY COMBINATIONS....................................................................... 8-48
8.3.7 BACKUP/RESTORE FOR SMART OPERATION PANEL
APPLICATION/SETTINGS FUNCTION ....................................................................... 8-49
Overview ................................................................................................................ 8-49
System application settings
*1
................................................................................ 8-49
Backup ................................................................................................................... 8-49
The default setting is “Enabled”. To change it to “Disabled”, uncheck “Enabled”.
Restarting the machine is not necessary. ............................................................. 8-50
Restore .................................................................................................................. 8-50
If restore fails, an error code appears on the operation panel. ............................. 8-50
8.3.8 SOFTWARE UPDATE ....................................................................................... 8-51
Updating the Smart Operation Panel .................................................................... 8-51
Installation/Update from a Media .......................................................................... 8-52
Creating a media card for update ......................................................................... 8-52
Installation/Update from the eDC Server .............................................................. 8-53
Log in to the control panel’s service mode. ........................................................... 8-53
Log in to the control panel’s service mode. ........................................................... 8-53
Log in to the control panel’s service mode. ........................................................... 8-54
Log in to the control panel’s service mode. ........................................................... 8-54
If you try to uninstall an activated application without first deactivating it, the
uninstallation will fail. However, the application can be uninstalled without
deactivation (forced uninstallation) in the following circumstances: ..................... 8-55
Application Site ...................................................................................................... 8-55
8.4 TROUBLESHOOTING ................................................................................................. 8-56
8.4.1 MULTITOUCH MISDETECTION BY THE OPERATION PANEL DUE TO AN AM
RADIO SIGNAL ............................................................................................................ 8-56
In "Checking the Influence of External Noise in the Installation Environment", if the
detection level is "3" or "4", you are receiving the external noise influence, so adjust
the sensitivity level. ............................................................................................... 8-57
8.4.2 PROBLEMS AND ERRORS RELATED TO HARDWARE ................................ 8-58
8.4.3 ERRORS RELATED TO APPLICATIONS ......................................................... 8-61
Applicable applications .......................................................................................... 8-61
To Next Page
Loading...
