ADF
D0CA/D0C9/D0C8/D0CB 4-68 SM
4. Turn over the ACC test pattern [A] and set it on the A DF. (Set the arrow position of the test
pattern in accordance with the arrow position of the photograph below.)
5. Exit the User Tools mode, and then enter the SP mode.
6. Execute SP4-482-001 (Read/Restore Std: Rear: Read New Chart).
7. When the correction is completed successfully, [A] is displayed.
If it failed, [B] will be displayed. Repeat steps 4 to 6.
To Next Page
Loading...
