Fusing
D0CA/D0C9/D0C8/D0CB 4-158 SM
Place a cloth or sheet of paper under the fusing unit when removing the fusing lower cover.
Otherwise, the screw(s) and gear(s) exposed after removing the cover will scratch or
transfer grease to the work surface.
2. Remove the springs [B], which are on both ends of the separation plate [A], from the holes
in the frame. (
× 2)
3. Remove the springs [B], which are on both ends of the separation plate [A], from the holes
in the separation plate. (
× 2)
To Next Page
Loading...
