Electrical Components
SM 4-221 D0CA/D0C9/D0C8/D0CB
&
Adjustment
7. Replace the SMB on the BCU with a new one.
• Install a new SMB [A] on the BiCU (PCB1) in the right direction. Incorrect
installation of the SMB will damage both the BiCU (PCB1) and SMB.
8. Plug in, and then turn ON the main power switch (SW1).
• When the power is turned ON, SC195-00 appears. Continue with the following
steps.
9. Select the destination setting (SP5-131-001 - JPN: 0, NA: 1, EU/AA/TWN/CHN: 2)
10. Set the machine serial number SP5-811-001, Area selection SP5-807-001, CPM set
SP5-882-001.
• For information on how to configure the above SPs, contact the supervisor in your
branch office.
11. Cycle the power OFF/ON.
12. Use SP5-801-002 “Memory Clear Engine”.
• After changing the SMB, some SPs may not have the correct values.
• Make sure that 12 must be done after Area selection SP5-807-001 and CPM set
SP5-882-001.
13. Turn OFF the machine, and then turn it back ON.
14. From the SD card where you saved the SMB data in step 5, download the SMB data with
SP5-825-001.
15. Turn OFF the machine, and then remove the SD card from SD slot 2.
16. Turn ON the main power switch (SW1).
17. Check the factory setting sheet and the SMC data printout from step 2, and set the user
tool and SP settings so they are the same as before.
18. Execute ACC (Copy and Printer).
To Next Page
Loading...
