Image Adjustment
D0CA/D0C9/D0C8/D0CB 4-264 SM
• Turning the knob counter-clockwise by 90 degrees changes the SP value by +1.
• Example:
SP value for magenta in Step 4 was “+6” Turn knob [C] 6 clicks (1 1/2
rotations) clockwise.
• SP value for yellow in Step 4 was “-7”
Turn knob [D] 7 clicks (1 3/4 rotations)
counter-clockwise.
3. Make sure that the front door is closed, and execute execute MUSIC (SP2-111-004).
4. Check the result for each color.
5. Rotate the knob(s) shown in the photo [A] to [D] at 90 degree intervals until the SP value for
the affected color(s) is within ±5 (target: 0).
6. Exit the SP mode.
7. Reattach the paper exit tray.
• Do not touch the LD units while installing the Paper Exit Tray. If the laser units
move, the color skew might have to be adjusted again.
To Next Page
Loading...
