Energy Save
SM 7-119 D0CA/D0C9/D0C8/D0CB
State Description
1 Standby/Printing
• State where normal operation is possible after warm-up
• State during printing
2 Printing
state/Panel OFF
State when printing with the backlight of the operation panel turned OFF
3 Fusing OFF State where the Standby Fusing OFF state is entered when the time set
with the "Fusing Unit Off Mode (Energy Saving) On/Off" setting of the
User Tools has elapsed.
• State where the operation panel is flashing and the fusing lamp is
OFF.
• The bottom plate of the paper feed tray is raised.
4 Quiet state Quiet state is entered when the Energy Saving key is pressed or the
time set with the "Sleep Mode Timer" of the User Too l s has elapsed.
This is a temporary energy saving state before entering sleep mode.
• Basically, no homing (initialization) of peripheral devices is
performed.
• The bottom plate of the paper feed tray is raised.
• The fusing lamp is turned OFF.
5 Engine OFF
(Sleep mode)
Entered from Quiet state with internal timer.
• The relevant power systems (24V, 12V, 5V) are turned OFF at the
same time as the fusing lamp.
• When printing is performed in engine OFF state, warm-up is started
and printing is performed while the backlight of the operation panel
is turned OF F.
6 STR state
(Sleep mode)
Supplying of power and clock to the CPU and peripheral chips on the
controller board (PCB24) is stopped.
To Next Page
Loading...
