Rohde & Schwarz MXO 4 Series - Page 179

Waveform analysisMXO 4 Series
179User Manual 1335.5337.02 ─ 07
Start Stop, Position range
Selects how the window for the zoom diagram is defined. You can select between
defining "Start Stop" values or "Position range".
Start Stop
The "Start Stop" tab allows you to specify start and stop values for the x- and y-axes.
The acquired data within these ranges is zoomed.
According to the selected "Mode", absolute or relative values are used.
"Start", "Relative start"
Defines the lower limit of the zoom area on the axis.
"Stop", "Relative stop"
Defines the upper limit of the zoom area on the axis.
Remote command:
LAYout<ly>:ZOOM<zo>:HORizontal:ABSolute:STARt on page 575
LAYout<ly>:ZOOM<zo>:HORizontal:RELative:STARt on page 577
LAYout<ly>:ZOOM<zo>:HORizontal:ABSolute:STOP on page 575
LAYout<ly>:ZOOM<zo>:HORizontal:RELative:STOP on page 577
LAYout<ly>:ZOOM<zo>:VERTical:RELative:STARt on page 580
LAYout<ly>:ZOOM<zo>:VERTical:ABSolute:STARt on page 579
LAYout<ly>:ZOOM<zo>:VERTical:RELative:STOP on page 581
LAYout<ly>:ZOOM<zo>:VERTical:ABSolute:STOP on page 579
Position range
If "Position range" is selected, you specify the x and y position of center point of the
zoom area plus a range for the x- and y-axes. The area defined by that point and the
ranges is zoomed. You can set absolute values or relative values (in percent of the
screen, depending on the "Mode" selection.
"Range"
Defines the width or height of the zoom area.
"Position"
Defines the x or y value of the centerpoint of the zoom area.
Remote command:
LAYout<ly>:ZOOM<zo>:HORizontal:ABSolute:POSition on page 574
LAYout<ly>:ZOOM<zo>:HORizontal:RELative:POSition on page 576
LAYout<ly>:ZOOM<zo>:HORizontal:ABSolute:SPAN on page 575
LAYout<ly>:ZOOM<zo>:HORizontal:RELative:SPAN on page 577
LAYout<ly>:ZOOM<zo>:VERTical:ABSolute:POSition on page 578
LAYout<ly>:ZOOM<zo>:VERTical:RELative:POSition on page 580
LAYout<ly>:ZOOM<zo>:VERTical:ABSolute:SPAN on page 579
LAYout<ly>:ZOOM<zo>:VERTical:RELative:SPAN on page 581
Set to screen
Sets the zoom area to the whole screen.
Remote command:
LAYout<ly>:ZOOM<zo>:SSCReen on page 581
Zoom