I/Q software interface (Option R&S RTP-K11)
R&S
®
RTP
1006User Manual 1337.9952.02 ─ 12
– The input signal is down-converted, filtered and resampled to the sample rate
of the output I/Q signal.
– One channel is required for each input signal. Thus up to four real signals can
be recorded in parallel.
– Sideband settings: see "Sideband (real input)" on page 1008.
●
Complex I/Q baseband signals
– The input signal is filtered and resampled to the sample rate of the output I/Q
signal.
– Two input channels are required for each input signal, one for the in-phase
component, and one for the quadrature component. Thus up to two complex
input signals can be recorded in parallel.
●
Complex I/Q signals in low IF range
I/Q sampling setup
To Next Page
Loading...
