Rohde & Schwarz RTP Series - Diagram Appearance Settings

Instrument setup
R&S
®
RTP
101User Manual 1337.9952.02 ─ 12
Show crosshair
If selected, a crosshair is displayed in the diagram area. A crosshair allows you to
select a specific data point by its co-ordinates.
Remote command:
DISPlay:DIAGram:CROSshair on page 1162
Keep X-grid fixed
If enabled, the vertical grid lines remain in their position when the horizontal position is
changed. Only the values at the grid lines are adapted.
Remote command:
DISPlay:DIAGram:XFIXed on page 1163
Keep Y-grid fixed
If enabled, the horizontal grid lines remain in their position when the position of the
curve is changed. Only the values at the grid lines are adapted. Fixed horizontal grid
lines correspond to the behavior of traditional oscilloscopes.
Remote command:
DISPlay:DIAGram:YFIXed on page 1163
Show div label (x)
If selected, the time scale value is shown at the diagram bottom instead of the horizon-
tal grid labels. For example, 10 ns/div is shown instead of the values 0, 10, 20, 30... ns.
4.3.4 Diagram appearance settings
Access: "Settings" > "Appearance" > "Diagram" tab
Appearance settings