Rohde & Schwarz RTP Series - Coupling & Sync

Remote control commands
R&S
®
RTP
2239User Manual 1337.9952.02 ─ 12
GENerator:ALIGnment:DC[:STARt]
Starts a DC offset alignment.
Usage: Event
Asynchronous command
22.19.6 Coupling & sync
WGENerator<m>:COUPling:STATe................................................................................2239
WGENerator<m>:COUPling:AMPLitude......................................................................... 2239
WGENerator<m>:COUPling:PHASeshift........................................................................ 2239
WGENerator<m>:COUPling[:FREQuency]......................................................................2240
WGENerator<m>:COUPling:NOISe............................................................................... 2240
WGENerator<m>:COUPling:AWForm............................................................................ 2240
GENerator:SYNC[:COMBination]...................................................................................2240
WGENerator<m>:COUPling:STATe <CplEnabSt>
Enables the coupling of the generators, with the selected set of parameters: amplitude,
frequency and noise.
Suffix:
<m>
.
1..2
Parameters:
<CplEnabSt> ON | OFF
*RST: OFF
WGENerator<m>:COUPling:AMPLitude <CoupleAmplitude>
Enables the coupling of all amplitude parameters of the generators.
Suffix:
<m>
.
1..2
Specifies the master generator.
Parameters:
<CoupleAmplitude> ON | OFF
*RST: OFF
WGENerator<m>:COUPling:PHASeshift <PhaseShift>
Sets the phase shift between the waveform of Gen1 and Gen2 when the frequency
parameters of the two waveforms are coupled.
Suffix:
<m>
.
1..2
Specifies the master generator.
Waveform generator (option R&S RTP-B6)