Rohde & Schwarz RTP Series - Page 2240

Remote control commands
R&S
®
RTP
2240User Manual 1337.9952.02 ─ 12
Parameters:
<PhaseShift> Range: -180 to 180
Increment: 1
*RST: 0
Default unit: °
WGENerator<m>:COUPling[:FREQuency] <CoupleFrequency>
Enables the coupling of all frequency parameters of the generators.
Suffix:
<m>
.
1..2
Specifies the master generator.
Parameters:
<CoupleFrequency> ON | OFF
*RST: OFF
WGENerator<m>:COUPling:NOISe
<CoupleNoise>
Couples all noise parameters of the generators.
Suffix:
<m>
.
1..2
Parameters:
<CoupleNoise> ON | OFF
*RST: OFF
WGENerator<m>:COUPling:AWForm <CplArbitraryWfm>
Enables the coupling of the arbitrary waveform of the generators.
Suffix:
<m>
.
1..2
Parameters:
<CplArbitraryWfm> ON | OFF
*RST: OFF
GENerator:SYNC[:COMBination] <Combination>
Sets which signals generated from the waveform generator are synchronized.
Parameters:
<Combination> NONE | GEN12 | G1PG | G2PG | G12PG
GEN12: Gen1 and Gen 2
GEN1PG/GEN2PG: Gen1/Gen 2 and Patt Gen
GEN12PG: Gen1,Gen 2 and Patt Gen
*RST: NONE
Waveform generator (option R&S RTP-B6)