Rohde & Schwarz RTP Series - Reports

Remote control commands
R&S
®
RTP
1543User Manual 1337.9952.02 ─ 12
22.16.10 Reports
The following commands configure and save report files. To configure the screenshot
that is included in the report, use the commands explained in Chapter 22.16.9,
"Screenshots", on page 1539.
REPort:LANGuage.......................................................................................................1543
REPort:PAPersize........................................................................................................1543
REPort:LOGType.........................................................................................................1543
REPort:LOGO..............................................................................................................1543
REPort:USER..............................................................................................................1544
REPort:COMMent........................................................................................................ 1544
REPort:FILE:NAME......................................................................................................1544
REPort:FILE:SAVE.......................................................................................................1544
REPort:LANGuage <Language>
Sets the language to be used in the report. Available languages are listed in the data
sheet.
Parameters:
<Language> String with the english language name, upper case.
Example:
REPort:LANGuage 'Spanish'
REPort:PAPersize <PaperSize>
Selects the paper size: A4 or US Letter.
Parameters:
<PaperSize> A4 | USL
*RST: A4
Usage: Asynchronous command
REPort:LOGType <Logo>
By default, the Rohde & Schwarz logo is shown in the header of the report pages. You
can switch the logo off, or select your logo to be shown.
Parameters:
<Logo> RS | CUST | NONE
CUST
Select the logo file using REPort:LOGO.
*RST: RS
Usage: Asynchronous command
REPort:LOGO <LogoFile>
Defines the logo file that is used on the report if REPort:LOGType is set to CUSTom.
Data management