Rohde & Schwarz RTP Series - Waveform Generator (Option R&S RTP-B6); Waveform Generator Setup

Remote control commands
R&S
®
RTP
2220User Manual 1337.9952.02 ─ 12
22.19 Waveform generator (option R&S RTP-B6)
22.19.1 Waveform generator setup
22.19.1.1 General
WGENerator<m>:ACOPy..............................................................................................2220
WGENerator<m>[:ENABle]........................................................................................... 2220
WGENerator<m>:SOURce............................................................................................2220
WGENerator<m>:PRESet.............................................................................................2220
WGENerator<m>:ACOPy
Copies all settings from Gen1/Gen2 and applies them to Gen2/Gen1.
Suffix:
<m>
.
1..2
Usage: Event
WGENerator<m>[:ENABle] <State>
Enables the waveform generator and outputs the waveform.
Suffix:
<m>
.
1..2
Parameters:
<State> ON | OFF
Usage: Asynchronous command
WGENerator<m>:SOURce <OperationMode>
Sets the operation mode for the the waveform generator.
Suffix:
<m>
.
1..2
Parameters:
<OperationMode> FUNCgen | MODulation | SWEep | ARBGenerator
*RST: FUNCgen
WGENerator<m>:PRESet
Sets the parameters of the waveform generator to their default values.
Waveform generator (option R&S
RTP-B6)