Waveform analysis
R&S
®
RTP
313User Manual 1337.9952.02 ─ 12
The quick-access history dialog box always shows the relative time. In the "History
Viewer" tab, you can select the time mode.
Remote command:
CHANnel<m>[:WAVeform<n>]:HISTory:TSDate? on page 1344
CHANnel<m>[:WAVeform<n>]:HISTory:TSABsolute? on page 1345
CHANnel<m>[:WAVeform<n>]:HISTory:TSRelative? on page 1345
CHANnel<m>[:WAVeform<n>]:HISTory:TSRReference? on page 1345
7.4.3 Using history
You can access the history waveforms in two ways:
●
Display a particular acquisition.
●
Replay all or a part of the saved waveforms to track the signal run.
Furthermore, you can export history data to a file.
●
"To open the history and get information" on page 313
●
"To display a particular acquisition" on page 313
●
"To replay history waveforms" on page 314
●
"To exit the history" on page 314
●
"To save the history data" on page 314
To open the history and get information
1. Press the [History] key on the front panel.
A running acquisition is stopped, the history mode is enabled and the quick-access
"History" dialog box is displayed. The [History] key lights up as long as the history
mode is active.
2. Open the full configuration dialog box:
●
Tap the
icon.
● Open "Menu" > "Acquire" dialog > "History" tab.
To display a particular acquisition
1. In the quick-access "History" dialog box, enter the number of the required acquisi-
tion in the "Current acq" field. The newest acquisition always has the index "0",
older acquisitions have a negative index.
2. Tap "Play" to start.
Alternatively, you can configure and start the history display from the "History" configu-
ration dialog box:
1. Open the "History" configuration tab.
2. If the history mode is off (the [History] key is not illuminated), select "Show".
The quick-access dialog box is displayed.
History
To Next Page
Loading...
