Rohde & Schwarz RTP Series - Search; General Search Settings

Remote control commands
R&S
®
RTP
1480User Manual 1337.9952.02 ─ 12
Parameters:
<PatOffsetY> Range: -100 to 100
Increment: 0.01
*RST: 0
Default unit: V
Parameters for setting and query:
<MaskTestName> String with the name of the mask test
Usage: Asynchronous command
22.15
Search
Some of the commands in the following chapter are asynchronous. An overlapping or
asynchronous command does not automatically finish executing before the next com-
mand starts executing. If overlapping commands must be executed in a defined order,
e.g. to avoid wrong measurement results, they must be serviced sequentially.
To prevent an overlapping execution of commands, one of the commands *OPC,
*OPC? or *WAI can be used after the command or a command set.
For more information, see:
●
www.rohde-schwarz.com/rc-via-scpi, chapter "Command Sequence and Synchro-
nization"
●
Chapter 22.3, "Programming examples", on page 1126
● General search settings...................................................................................... 1480
● Basic trigger search conditions........................................................................... 1482
● Edge search conditions.......................................................................................1485
● Glitch search conditions......................................................................................1485
● Interval search conditions................................................................................... 1486
● Runt search conditions........................................................................................1488
● Slew rate search conditions................................................................................ 1490
● Timeout search conditions.................................................................................. 1493
● Width search conditions......................................................................................1493
● Window search conditions.................................................................................. 1495
● Data2clock search conditions............................................................................. 1498
● Pattern search conditions....................................................................................1500
● State search conditions.......................................................................................1504
● Search on spectrum............................................................................................1507
● Search gate settings........................................................................................... 1508
● Search results..................................................................................................... 1511
22.15.1 General search settings
SEARch:ADD.............................................................................................................. 1481
SEARch:CLEar............................................................................................................1481
SEARch:REMove.........................................................................................................1481
Search