Mask testing
R&S
®
RTP
447User Manual 1337.9952.02 ─ 12
To load a mask
1. Tap "Open".
2. Select the file from the file selection dialog box.
10.4.6 Mask testing on history acquisitions
In the same way as for running acquisitions, you can set up and perform the mask test-
ing also on history waveforms.
The requirements for mask testing on history waveforms are also the same:
●
The mask is defined, see Chapter 10.4.1.1, "Creating user masks", on page 440
and Chapter 10.4.1.2, "Modifying user masks", on page 442.
●
The mask test is defined, see Chapter 10.4.2, "Setting up a mask test",
on page 445
●
The mask display is configured, see Chapter 10.4.3, "Configuring the mask and hit
display", on page 445.
1. Perform and finish the acquisition.
2. Press [History].
3. In the quick-access "History" dialog box, tap "Play".
The mask testing is performed on the complete history memory, starting with the
oldest acquisition. The state of the mask test is set to "Finished" when "Nx Single
count" acquisitions are tested.
For details on history, see Chapter 7.4.1, "About history", on page 309.
Working with masks
To Next Page
Loading...
