Rohde & Schwarz RTP Series - Instrument Setup; System

Remote control commands
R&S
®
RTP
1157User Manual 1337.9952.02 ─ 12
Parameters:
<DispMessState> ON | OFF
*RST: OFF
Firmware/software: Version 2.70
SYSTem:DISPlay:MESSage[:TEXT] <DisplayMessage>
Defines an additional text that is displayed during remote control operation.
To enable the text display, use SYSTem:DISPlay:MESSage:STATe on page 1156.
Parameters:
<DisplayMessage> String that contains the text.
Firmware/software: Version 2.70
SYSTem:LANGuage <Language>
Defines the remote control behavior of the instrument and sets the remote control com-
mand set.
Parameters:
<Language> String value. Available values:
'SCPI': R&S RTP remote command set is used.
"DPO7000" or 'TDS540': Compatible remote command set of
Tektronix oscilloscopes DPO7000 or TDS540 is used.
Options: R&S RTP-K301
22.7 Instrument setup
22.7.1 System
SYSTem:PRESet......................................................................................................... 1157
SYSTem:DATE.............................................................................................................1158
SYSTem:TIME?........................................................................................................... 1158
SYSTem:DEVice:ID?.................................................................................................... 1158
DIAGnostic:SERVice:COMPutername............................................................................ 1158
SYSTem:PRESet
Resets the instrument to the factory default settings, to the initial state. Factory settings
comprise all instrument settings, including display, intensity and transparency settings.
After loading factory defaults, perform a self-alignment to synchronize the signal data.
Usage:
Event
Instrument setup