Protocol analysis
R&S
®
RTP
720User Manual 1337.9952.02 ─ 12
8. Enable "Decode".
13.14.3 M-PHY trigger
13.14.3.1 M-PHY trigger settings
Access: [Protocol] > "Shortcuts" tab > "Setup trigger"
Make sure that:
●
In the [Protocol] > "Setup" tab:
– The correct "Protocol" is selected.
– The data sources of the serial bus are channel signals.
●
In the "Trigger" > "Setup" tab:
– The "Trigger on" = "Single event"
– The trigger "Source" = "Serial bus".
– The correct "Serial bus" is selected.
Type
Selects the trigger type for the analysis of the selected protocol.
Remote command:
TRIGger<m>:MPHY:TYPE on page 1878
Start of frame ← Type
Triggers on the start of an M-PHY or a UniPro frame.
Burst ← Type
Triggers on an M-PHY burst frame.
Adapt ← Type
Triggers on an M-PHY Adapt frame. This control frame is used for clock/bit synchroni-
zation.
LCC ← Type
Triggers on an M-PHY Line Control Command (LCC) frame that matches the specified:
●
LCC Type
●
WORD
This control frame is used for configuring the line to a different state or mode depend-
ing on the LCC type.
M-PHY and USB SSIC (option R&S
RTP-K44 and K64)
To Next Page
Loading...
