Protocol analysis
R&S
®
RTP
523User Manual 1337.9952.02 ─ 12
●
Specific data pattern in the message
13.2.2 I²C configuration
13.2.2.1 I²C configuration settings
Access: [Protocol] > "Setup" tab > "Protocol" = I2C
Make sure that the tab of the correct serial bus is selected.
See also:
Chapter 13.1.1, "Setup - general settings", on page 512
SDA, SCL
Set the waveforms of the data line (SDA) and clock line (SCL).
Usually, the source is one of the analog channels. Reference and math waveforms are
available as source if the trigger source is one of the analog channels but not the serial
bus.
Do not combine a reference waveform with channel or math waveform because the
time correlation of these waveforms might differ.
I²C (option R&S
RTP-K1)
To Next Page
Loading...
