Rohde & Schwarz RTP Series - Configuring and Saving Screenshots

Data and file management
R&S
®
RTP
506User Manual 1337.9952.02 ─ 12
Remote command:
HCOPy:DEVice<m>:LANGuage on page 1540
HCOPy:DESTination<1..2> on page 1539
MMEMory:NAME on page 1540
HCOPy:IMMediate<m>[:DUM] on page 1542
HCOPy:IMMediate<m>:NEXT on page 1542
MMEMory:DELete on page 1521
12.3.2 Configuring and saving screenshots
You can edit the image, invert all colors, and set the background color. A preview of the
current image is shown for reference.
1. Open the "Menu" > "Save/Recall" > "Save" tab > "Screenshot".
2. To enhance the images for later print on white paper, enable "White background" or
"Inverse color". If you print this image later on a monochrome printer, you get a
grayscaled picture. The contrast of the resulting gray lines depends on waveform
colors and the used printer.
3. Select the file format: png, jpg, or another one.
4. To change the directory, tap "Save As" and configure the path.
The symbols of often used target folders are listed on the left of the file explorer. By
default, screenshots are saved in the
C:\Users\Public\Public Documents\Rohde-Schwarz\RTx\
ScreenShots directory.
5. Tap "Save".
The file is saved and the dialog box closes.
6. Check if the screenshot is saved to the desired directory.
7. To save further screenshots, use one of the following ways:
● Configure the [Camera] key. Press the key to save a screenshot.
See also Chapter 4.5.1, "Hardkeys: function assignment", on page 116.
● Add the "Image" icon to the toolbar. Tap the icon to save an image.
See also Chapter 3.3.6.2, "Configuring the toolbar", on page 74.
● Tap "Save" in the "Screenshot" dialog box to save the image to the specified
file.
● To save the image with a dedicated filename or to another directory, tap "Save
As" in the "Screenshot" dialog box. Select the path, enter a filename, and tap
"Save".
Screenshots