Deembedding (Option R&S RTP-K121/-K122)
R&S
®
RTP
1062User Manual 1337.9952.02 ─ 12
S-parameters can be listed as complex numbers (real and imaginary parts), or as
magnitude and phase in the order of increasing frequency. The phase unit has to
be degree (°).
Proceed as follows:
1. Open the [ App Cockpit] > "Analysis" menu
2. Select "Deembedding".
3. Select the input channel to which the measurement setup is connected.
4. Add the components of the measurement setup:
a) Tap the "+" icon.
b) Select the component type.
The component is added to the setup, and it is disabled by default (bypassed). The
DUT and a probe or other input component are included by default.
5. Configure each component:
a) Tap the "Configure" button.
b) Enter the settings as required.
All settings are described in Chapter 19.2, "Deembedding settings",
on page 1062.
c) If necessary, tap "Open" and load the S-parameters from file.
As long as the configuration is incomplete or conflicting, the message "Invalid
configuration" is shown.
d) Enable the component to consider it during deembedding.
e) Tap the subtab of the next component, and configure it in the same way.
6. On the "Setup" tab, set the Effective bandwidth and the Delay compensation.
7. Enable the deembedding.
8. If you want to keep the configuration for later use, save it to file.
19.2 Deembedding settings
19.2.1 Measurement setup
In the "Deembedding" > "Setup" tab, you add all components of the measurement
setup and define all settings that are related to the complete path.
Deembedding settings
To Next Page
Loading...
