Rohde & Schwarz RTP Series - Search Results

Remote control commands
R&S
®
RTP
1511User Manual 1337.9952.02 ─ 12
Example: Prerequisite: Search1 and Zoom2 are available.
SEARch:GATE:ZCOupling 'Search1',ON
SEARch:GATE:ZDIagram 'Search1','Diagram1','Zoom2'
SEARch:GATE:ZDIagram? 'Search1'
<-- Diagram1;Zoom2
SEARch:GATE:STATe 'Search1', ON
SEARch:GATE:SHOW 'Search2', ON
Enables the zoom coupling to define the gate,and selects
Zoom2 as gate area. Zoom2 is based on Diagram1. Then the
gate is activated and displayed.
Usage: Asynchronous command
22.15.16
Search results
SEARch:RESDiagram:HORZ:ABSolute:POSition............................................................ 1511
SEARch:RESDiagram:HORZ:ABSolute:SPAN................................................................ 1512
SEARch:RESDiagram:HORZ:MODE..............................................................................1512
SEARch:RESDiagram:HORZ:RELative:POSition............................................................ 1512
SEARch:RESDiagram:HORZ:RELative:SPAN.................................................................1512
SEARch:RESDiagram:SHOW....................................................................................... 1513
SEARch:RESDiagram:VERT:ABSolute:POSition.............................................................1513
SEARch:RESDiagram:VERT:ABSolute:SPAN................................................................. 1513
SEARch:RESDiagram:VERT:MODE.............................................................................. 1514
SEARch:RESDiagram:VERT:RELative:POSition............................................................. 1514
SEARch:RESDiagram:VERT:RELative:SPAN..................................................................1514
SEARch:RESult:LIMit................................................................................................... 1514
SEARch:RESult:SHOW................................................................................................1515
SEARch:RESult:SORT:ASCending................................................................................ 1515
SEARch:RESult:SORT[:MODE].....................................................................................1515
SEARch:RESult[:ALL]?.................................................................................................1516
SEARch:RESDiagram:HORZ:ABSolute:POSition <SearchName>,<Position>
SEARch:RESDiagram:HORZ:ABSolute:POSition? <SearchName>
Defines the x-value of the centerpoint of the zoom area.
Parameters:
<Position> Range: -100E+24 to 100E+24
Increment: 0.01
*RST: 0.01
Parameters for setting and query:
<SearchName> Search definition
Usage: Asynchronous command
Search