Rohde & Schwarz RTP Series - Pattern Search Conditions

Remote control commands
R&S
®
RTP
1500User Manual 1337.9952.02 ─ 12
Parameters for setting and query:
<SearchName> Search definition
Usage: Asynchronous command
SEARch:TRIGger:SETHold:STIMe <SearchName>,<SetupTime>
SEARch:TRIGger:SETHold:STIMe? <SearchName>
Sets the minimum time before the clock edge while the data signal must stay steady
above or below the data level.
The setup time can be negative. In this case, the hold time is always positive. The
setup/hold interval starts after the clock edge (setup time) and ends after the clock
edge (hold time). If you change the negative setup time, the hold time is adjusted by
the intrument.
Parameters:
<SetupTime> Range: -99.999E-9 to 0.1
Increment: 1E-9
*RST: 0
Default unit: s
Parameters for setting and query:
<SearchName> Search definition
Usage: Asynchronous command
22.15.12 Pattern search conditions
SEARch:TRIGger:PATTern:A[:ENABle]...........................................................................1501
SEARch:TRIGger:PATTern:B[:ENABle]...........................................................................1501
SEARch:TRIGger:PATTern:C[:ENABle].......................................................................... 1501
SEARch:TRIGger:PATTern:D[:ENABle].......................................................................... 1501
SEARch:TRIGger:PATTern:A:LOGic...............................................................................1501
SEARch:TRIGger:PATTern:B:LOGic...............................................................................1501
SEARch:TRIGger:PATTern:C:LOGic.............................................................................. 1501
SEARch:TRIGger:PATTern:D:LOGic.............................................................................. 1501
SEARch:TRIGger:PATTern:AB:LOGic............................................................................ 1502
SEARch:TRIGger:PATTern:CD:LOGic............................................................................1502
SEARch:TRIGger:PATTern:ABCD:LOGic........................................................................1502
SEARch:TRIGger:PATTern:MODE.................................................................................1502
SEARch:TRIGger:PATTern:TIMeout:MODE.................................................................... 1503
SEARch:TRIGger:PATTern:TIMeout[:TIME].................................................................... 1503
SEARch:TRIGger:PATTern:WIDTh:RANGe.....................................................................1503
SEARch:TRIGger:PATTern:WIDTh[:WIDTh]....................................................................1504
SEARch:TRIGger:PATTern:WIDTh:DELTa...................................................................... 1504
Search