Rohde & Schwarz RTP Series - General Settings

Remote control commands
R&S
®
RTP
1360User Manual 1337.9952.02 ─ 12
Some of the commands in the following chapter are asynchronous. An overlapping or
asynchronous command does not automatically finish executing before the next com-
mand starts executing. If overlapping commands must be executed in a defined order,
e.g. to avoid wrong measurement results, they must be serviced sequentially.
To prevent an overlapping execution of commands, one of the commands *OPC,
*OPC? or *WAI can be used after the command or a command set.
For more information, see:
●
www.rohde-schwarz.com/rc-via-scpi, chapter "Command Sequence and Synchro-
nization"
●
Chapter 22.3, "Programming examples", on page 1126
● General settings..................................................................................................1360
● Results................................................................................................................ 1366
● Amplitude/time measurements............................................................................1370
● Arithmetic for amplitude/time and spectrum measurements...............................1380
● Eye diagram measurements............................................................................... 1388
● Spectrum.............................................................................................................1391
● Histograms..........................................................................................................1398
● Display................................................................................................................ 1408
● Statistics and long-term measurements..............................................................1410
● Protocol...............................................................................................................1416
● Track and trend................................................................................................... 1422
● Gating..................................................................................................................1423
● Limit check and event actions.............................................................................1426
● Reference levels................................................................................................. 1429
22.12.1 General settings
MEASurement<m>[:ENABle].........................................................................................1360
MEASurement<m>:SOURce.........................................................................................1361
MEASurement<m>:FSRC.............................................................................................1362
MEASurement<m>:SSRC.............................................................................................1362
MEASurement<m>:CATegory........................................................................................1363
MEASurement<m>:MAIN..............................................................................................1364
MEASurement<m>:ADDitional.......................................................................................1365
MEASurement<m>:AON...............................................................................................1365
MEASurement<m>:AOFF............................................................................................. 1365
MEASurement<m>[:ENABle] <State>
Switches the indicated measurement on or off.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1359.
Automatic measurements