Rohde & Schwarz RTP Series - Histograms

Remote control commands
R&S
®
RTP
1398User Manual 1337.9952.02 ─ 12
Parameters:
<UpperLimit> Range: -100 to 100
Increment: 10E-6
*RST: 0
Usage: Asynchronous command
MEASurement<m>:SPECtrum:LCHeck<n>:LOWer:MARGin <LowerMargin>
MEASurement<m>:SPECtrum:LCHeck<n>:UPPer:MARGin <UpperMargin>
Define the lower and upper margins for the limit check, respectively. Margins are not as
strict as limits and must be within the valid value range. The valid range is defined
using the MEASurement<m>:SPECtrum:LCHeck<n>:VALid command.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1359.
<n> 1..15
Number of the spectrummeasurement, see Table 22-8.
Parameters:
<UpperMargin> Range: -100 to 100
Increment: 10E-6
*RST: 0
Usage: Asynchronous command
22.12.7 Histograms
See also: Chapter 22.16.6, "Waveform histogram export to file", on page 1535
● Histogram display................................................................................................1398
● Histogram measurement.....................................................................................1404
22.12.7.1 Histogram display
LAYout:HISTogram:ADD............................................................................................... 1399
LAYout:HISTogram:SOURce......................................................................................... 1400
LAYout:HISTogram:MODE............................................................................................ 1400
LAYout:HISTogram:HORZ:MODE.................................................................................. 1401
LAYout:HISTogram:HORZ:ABSolute:STARt.................................................................... 1401
LAYout:HISTogram:HORZ:ABSolute:STOP.....................................................................1401
LAYout:HISTogram:HORZ:RELative:STARt.....................................................................1402
LAYout:HISTogram:HORZ:RELative:STOP..................................................................... 1402
LAYout:HISTogram:VERTical:MODE.............................................................................. 1402
LAYout:HISTogram:VERTical:ABSolute:STARt................................................................ 1402
LAYout:HISTogram:VERTical:ABSolute:STOP.................................................................1403
LAYout:HISTogram:VERTical:RELative:STARt.................................................................1403
Automatic measurements