Protocol analysis
R&S
®
RTP
619User Manual 1337.9952.02 ─ 12
9. Enable "Decode".
13.8.3 ARINC 429 trigger
13.8.3.1 ARINC 429 trigger settings
Access: [Protocol] > "Shortcuts" tab > "Setup trigger"
Make sure that:
●
In the [Protocol] > "Setup" tab:
– The correct "Protocol" is selected.
– The data sources of the serial bus are channel signals.
●
In the "Trigger" > "Setup" tab:
– The "Trigger on" = "Single event"
– The trigger "Source" = "Serial bus".
– The correct "Serial bus" is selected.
Trigger Type
Selects the trigger type for ARINC 429 analysis.
"Word Start"
Sets the trigger to the start of the word.
"Word Stop"
Sets the trigger to the stop of the word.
ARINC 429 (option R&S RTP-K7)
To Next Page
Loading...
