Rohde & Schwarz RTP Series - Signal Settings

Instrument setup
R&S
®
RTP
113User Manual 1337.9952.02 ─ 12
Enable
If enabled, each new data point in the diagram area remains on the screen for the
duration that is defined using Time, or as long as Infinite persistence is selected.
If disabled, the waveform points are displayed only for the current acquisition.
Remote command:
DISPlay:PERSistence[:STATe] on page 1180
Infinite persistence
If infinite persistence is enabled, each new waveform point remains on the screen until
this option is disabled. Use infinite persistence to display rare events in the signal.
Remote command:
DISPlay:PERSistence:INFinite on page 1180
Time
Sets a time factor that controls how long the waveforms points fade away from the dis-
play. Thus, the R&S RTP emulates the persistence of analog phosphor screens.
Remote command:
DISPlay:PERSistence:TIME on page 1180
Reset
Resets the display, removing persistent all waveform points.
Remote command:
DISPlay:PERSistence:RESet on page 1180
4.4.2 Signal settings
Access: "Menu" > "Settings" > "Display" > "Signal"
Display settings