Rohde & Schwarz RTP Series - Noise Setup

Remote control commands
R&S
®
RTP
2237User Manual 1337.9952.02 ─ 12
22.19.4 Noise setup
WGENerator<m>:MODulation:NDCLevel........................................................................2237
WGENerator<m>:MODulation:NLABsolute?................................................................... 2237
WGENerator<m>:MODulation:NLPCent......................................................................... 2237
WGENerator<m>:MODulation:NOISe.............................................................................2237
WGENerator<m>:MODulation:NDCLevel <LevelDC>
Sets the DC noise level.
Suffix:
<m>
.
1..2
Parameters:
<LevelDC> Range: 0 to 12
Increment: 0.1
*RST: 0.01
Default unit: V
WGENerator<m>:MODulation:NLABsolute?
Queries the level of the noise in volts.
Suffix:
<m>
.
1..2
Return values:
<LevelAbs> Range: 0 to 12
Increment: 0.1
*RST: 0
Default unit: V
Usage: Query only
WGENerator<m>:MODulation:NLPCent <LevelPct>
Sets the noise level in percentage of the amplitude.
Suffix:
<m>
.
1..2
Parameters:
<LevelPct> Range: 0 to 100
Increment: 1
*RST: 0
Default unit: %
WGENerator<m>:MODulation:NOISe <State>
Enables the adding of noise to the waveform.
Waveform generator (option R&S
RTP-B6)