Rohde & Schwarz RTP Series - Displaying Results

Getting started
R&S
®
RTP
80User Manual 1337.9952.02 ─ 12
3.3.7 Displaying results
The results of measurements, mask tests, searches, protocol decoding and others are
displayed immediately. There are several places to display the results:
●
In a table that is docked below the diagram (not available for mask test results)
●
In a floating result box in front of the diagrams, which you can move on the display
●
In a minimized view (result icon) on the signal bar
●
In a separate that can be arranged similar to a diagram
The default position and the font size can be adjusted.
To define the default position of measurement results
For results of automatic, cursor measurements and protocol measurements, the
docked position below the diagram is the initial default position.
To change the default position of the results:
► Open the "Menu" > "Settings" > "Appearance" dialog.
● Automatic measurements: select "Measurement" tab > "Result position".
● Cursor measurements: select "Cursor" tab > "Result position".
● Protocols: select "Protocol" tab > "Result position".
To arrange the results on the display
1. If the results are listed in a docked table, touch and hold a result line and drag it.
The results are now shown in a result box.
Note: Once you undock the measurement results, you cannot move the result box
back to the docked position.
2. Touch and hold the title of the result box and drag the box on the screen. The
SmartGrid indicates where the result box will be placed.
● If you drop the box on one of the buttons, the results are shown in a separate
tab besides, above, or below the diagram.
● If you drop the box on the signal bar, a result icon is created.
● If you drop the box somewhere else, a floating result box is placed.
Operating the instrument