Rohde & Schwarz RTP Series - Timeout Trigger

Remote control commands
R&S
®
RTP
1266User Manual 1337.9952.02 ─ 12
Suffix:
<m>
.
1..3
1 = A-trigger, 2 = B-trigger, 3 = R-trigger
Parameters:
<Width> Range: 100E-12 to 10000
Increment: 100E-9
*RST: 5E-9
Default unit: s
Usage: Asynchronous command
TRIGger<m>:WINDow:DELTa
<WidthDelta>
Defines a range around the "Width" value specified using TRIGger<m>:WINDow:
WIDTh.
Suffix:
<m>
.
1..3
1 = A-trigger, 2 = B-trigger, 3 = R-trigger
Parameters:
<WidthDelta> Range: 0 to 432
Increment: 500E-12
*RST: 0
Default unit: s
Usage: Asynchronous command
22.9.7 Timeout trigger
TRIGger<m>:TIMeout:RANGe.......................................................................................1266
TRIGger<m>:TIMeout:TIME..........................................................................................1267
TRIGger<m>:TIMeout:RANGe <TimeoutMode>
Defines the relation of the signal level to the trigger level.
Suffix:
<m>
.
1..3
1 = A-trigger, 2 = B-trigger, 3 = R-trigger
Parameters:
<TimeoutMode> HIGH | LOW | EITHer
HIGH
The signal level stays above the trigger level.
LOW
The signal level stays below the trigger level.
EITHer
The signal level stays above or below the trigger level.
*RST: HIGH
Trigger