Rohde & Schwarz RTP Series - Result Analysis

Measurements
R&S
®
RTP
387User Manual 1337.9952.02 ─ 12
"Value"
Sets a value for the selected field.
"Field to be
tracked"
Selects the type of field which value is tracked over time.
Remote command:
MEASurement<m>:PROTocol:FLDValue:FLD on page 1419
MEASurement<m>:PROTocol:FLDValue:FRM on page 1419
MEASurement<m>:PROTocol:FLDValue:TRCK on page 1419
MEASurement<m>:PROTocol:FLDValue:VAL on page 1419
Main bit rate / 2nd bit rate
Opens a dialog to set up the parameters for the main bit rate/ 2nd bit rate measure-
ment. You can identify a frame and a specific field value.
The types of available frames and fields depend on the enabled protocol, see
Table 8-10.
If a label list is loaded and enabled for the protocol, sometimes there are defined calcu-
lations and formatting for the displayed field value. In this case, the measurement dis-
plays the value according to the definition in the label list.
"Frame"
Selects the type of frame.
"Field"
Selects the type of field.
"Value"
Sets a value for the selected field.
Remote command:
MEASurement<m>:PROTocol:MBITrate:FLD on page 1420
MEASurement<m>:PROTocol:MBITrate:FRM on page 1420
MEASurement<m>:PROTocol:MBITrate:VAL on page 1420
MEASurement<m>:PROTocol:SBITrate:FLD on page 1420
MEASurement<m>:PROTocol:SBITrate:FRM on page 1420
MEASurement<m>:PROTocol:SBITrate:VAL on page 1421
8.2.11 Result analysis
The behavior of measurement results over time can be evaluated in different ways:
●
Statistics
●
Long-term measurements
●
Histograms on measurement results
●
Track
Automatic measurements