Rohde & Schwarz RTP Series - Pattern Trigger; State Trigger

Remote control commands
R&S
®
RTP
1273User Manual 1337.9952.02 ─ 12
The setup time can be negative. In this case, the hold time is always positive. The
setup/hold interval starts after the clock edge (setup time) and ends after the clock
edge (hold time). If you change the negative setup time, the hold time is adjusted by
the instrument.
Suffix:
<m>
.
1..3
Only 1 = A-trigger, 2 | 3 = not available. Can be omitted.
Parameters:
<SetupTime> Range: -99.999E-9 to 100E-9
Increment: 1E-9
*RST: 0
Default unit: s
Usage: Asynchronous command
TRIGger<m>:SCOupling
<TrigLevSrcCpl>
Sets the trigger levels of all used channels to the level of the data line (Data2clock trig-
ger), clock line (state trigger) or source line (pattern trigger).
Suffix:
<m>
.
1..3
Only 1 = A-trigger, 2 | 3 = not available. Can be omitted.
Parameters:
<TrigLevSrcCpl> ON | OFF
*RST: OFF
Usage: Asynchronous command
22.9.11 State trigger
The state trigger combines the edge trigger settings with trigger qualification. It is only
available for the A-event (Suffix = 1).
Use the following commands:
●
TRIGger<m>:EDGE:SLOPe on page 1256
●
TRIGger<m>:LEVel<n>[:VALue] on page 1255
●
TRIGger<m>:SCOupling on page 1273
●
To define the state, use the TRIG:QUAL...[ENABle] and TRIG:QUAL...LOGic
commands, which are described in Chapter 22.9.16, "Trigger qualification",
on page 1300.
22.9.12 Pattern trigger
The pattern trigger is only available for the A-event (Suffix = 1).
Trigger