Protocol analysis
R&S
®
RTP
638User Manual 1337.9952.02 ─ 12
Column Description
Destination Symbol Translation (or symbolic label) of the destination address, if the label list is
enabled.
Source Symbol Translation (or symbolic label) of the source address, if the label list is enabled.
Number of Words Number of words in the frame
Bit rate Value of the bit rate
Tools
Press "Display settings" in the "Deode Reults" table, to access the "Display" tab.
Remote commands
Remote commands are described in Chapter 22.17.10.3, "Decode results",
on page 1735.
13.9.5 Search on decoded Ethernet data
Using the search functionality, you can find various events in the decoded data. You
can find the same events that you can trigger on, and even many more, since several
event types can also be combined.
Before you can start the search, you have to configure the bus correctly and acquire
decoded data.
To search on decoded data, set the search source to "SerBus" for the configured proto-
col.
For general information on how to handle the search functionality, see Chapter 11,
"Search functions", on page 448.
If you need information on how to get started with searching Ethernet data, see Chap-
ter 13.9.5.3, "Searching Ethernet data", on page 641. Otherwise proceed with the
Ethernet search setup.
13.9.5.1 Ethernet search setup
Access: [Protocol] > "Shortcuts" tab > "Setup search"
Ethernet 10BASE-T and 100BASE-TX (option R&S
RTP-K8)
To Next Page
Loading...
