Search functions
R&S
®
RTP
451User Manual 1337.9952.02 ─ 12
Depending on the selected source, different search criteria are available.
Remote command: 
SEARch:SOURce on page 1481
Edge, Glitch, Width, Runt, Window, Timeout, Interval, Slew rate, Setup & Hold,
State, Pattern
Search criteria for analog and digital input signals, math and reference waveforms, and
tracks. For searching on digital channels, only "Edge", "Width", "Timeout" and "Setup &
Hold" criteria are available.
Tap the icon to include or exclude the search criteria in the next search. You can
enable several event types for simultaneous search.
Remote command: 
SEARch:TRIGger:EDGE[:STATe] on page 1483
SEARch:TRIGger:GLITch[:STATe] on page 1483
SEARch:TRIGger:WIDTh[:STATe] on page 1483
SEARch:TRIGger:RUNT[:STATe] on page 1483
SEARch:TRIGger:WINDow[:STATe] on page 1483
SEARch:TRIGger:TIMeout[:STATe] on page 1483
SEARch:TRIGger:INTerval[:STATe] on page 1483
SEARch:TRIGger:SLEWrate[:STATe] on page 1483
SEARch:TRIGger:SETHold[:STATe] on page 1483
SEARch:TRIGger:STATe[:STATe] on page 1483
SEARch:TRIGger:PATTern[:STATe] on page 1483
Copy from trigger A'
Copies the trigger type-specific settings from the A-trigger configuration to the search
settings. The source itself is not copied.
Remote command: 
SEARch:TRIGger:EDGE:ACOPy on page 1484
SEARch:TRIGger:GLITch:ACOPy on page 1484
SEARch:TRIGger:WINDow:ACOPy on page 1484
SEARch:TRIGger:WIDTh:ACOPy on page 1484
SEARch:TRIGger:RUNT:ACOPy on page 1484
SEARch:TRIGger:WINDow:ACOPy on page 1484
SEARch:TRIGger:TIMeout:ACOPy on page 1484
SEARch:TRIGger:INTerval:ACOPy on page 1484
SEARch:TRIGger:SLEWrate:ACOPy on page 1484
SEARch:TRIGger:SETHold:ACOPy on page 1484
SEARch:TRIGger:STATe:ACOPy on page 1484
SEARch:TRIGger:PATTern:ACOPy on page 1484
11.2.2  Search parameters
Most parameters available for trigger event definition can also be configured as search
conditions. Each event type is defined in a separate subtab.
If the source is a spectrum, the instrument performs a frequency marker search.
Search setup