Remote control commands
R&S
®
RTP
1186User Manual 1337.9952.02 ─ 12
Return values:
<DeviceFootprint> Content of the device footprint xml file as block data
DIAGnostic:SERVice:FWVersion?
Returns the firmware version that is currently installed on the instrument.
Return values:
<FirmwareVersion> Version string
Usage: Query only
DIAGnostic:SERVice:PARTnumber
<MaterialNumber>
Returns the material number of your instrument. This number is required to order a
new option, and in case of service.
Parameters:
<MaterialNumber> Number string
DIAGnostic:SERVice:SERialnumber?
Returns the serial number of your instrument. This number is required to order a new
option, and in case of service.
Return values:
<SerialNumber> Number string
Usage: Query only
DIAGnostic:SERVice:CHANnelcount?
Queries the number of available channels.
Return values:
<ChannelCount> Range: 0 to 4
Increment: 1
*RST: 0
Usage: Query only
Firmware/software: V 2.00
22.8 Acquisition and setup
Some of the commands in the following chapter are asynchronous. An overlapping or
asynchronous command does not automatically finish executing before the next com-
mand starts executing. If overlapping commands must be executed in a defined order,
e.g. to avoid wrong measurement results, they must be serviced sequentially.
Acquisition and setup
To Next Page
Loading...
