Protocol analysis
R&S
®
RTP
784User Manual 1337.9952.02 ─ 12
Table 13-24: Content of the decode result table
Column Description
Symbol Shows the index number of the symbol
State Overall state of the symbol
Start Time of the symbol start in relation to the trigger point
K/D Code The K/D code
8-bit The 8-bit value
10-bit 10-bit output value
Tools
Press "Display settings" in the "Deode Reults" table, to access the "Display" tab.
Remote commands
Remote commands are described in Chapter 22.17.17.3, "Decode results",
on page 1981.
13.16.5 Search on decoded 8b/10b data
Using the search functionality, you can find various events in the decoded data, the
same events which you also can trigger on. Before you can start the search, you have
to configure the bus correctly and acquire decoded data.
To search on decoded data, set the search "Source" to the serial bus that is configured
for the protocol to be analyzed.
See also Chapter 11, "Search functions", on page 448.
13.16.5.1 8b/10b search setup
Access: [Protocol] > "Shortcuts" tab > "Setup search"
8b/10b (option R&S
RTP-K52)
To Next Page
Loading...
