Rohde & Schwarz RTP Series - Cursor Setup

Remote control commands
R&S
®
RTP
1349User Manual 1337.9952.02 ─ 12
For more information, see:
●
www.rohde-schwarz.com/rc-via-scpi, chapter "Command Sequence and Synchro-
nization"
●
Chapter 22.3, "Programming examples", on page 1126
22.11.1 Cursor setup..............................................................................................................1349
22.11.2 Cursor results............................................................................................................1357
22.11.3 Peak search using cursors........................................................................................1358
22.11.1 Cursor setup
CURSor<m>:STATe......................................................................................................1349
CURSor<m>:AOFF...................................................................................................... 1349
CURSor<m>:FUNCtion.................................................................................................1350
CURSor<m>:SOURce..................................................................................................1350
CURSor<m>:SSOurce..................................................................................................1351
CURSor<m>:USSource................................................................................................1352
CURSor<m>:TRACking[:STATe].................................................................................... 1353
CURSor<m>:X1Position............................................................................................... 1353
CURSor<m>:X2Position............................................................................................... 1353
CURSor<m>:XCOupling............................................................................................... 1354
CURSor<m>:Y1Position............................................................................................... 1354
CURSor<m>:Y2Position............................................................................................... 1354
CURSor<m>:YCOupling............................................................................................... 1355
CURSor<m>:X1ENvelope.............................................................................................1355
CURSor<m>:X2ENvelope.............................................................................................1356
CURSor<m>:LABel...................................................................................................... 1356
CURSor<m>:SIAD....................................................................................................... 1356
CURSor<m>:STATe <State>
Switches the indicated cursor on or off.
Suffix:
<m>
.
1..4
Selects the cursor set.
Parameters:
<State> ON | OFF
*RST: OFF
Usage: Asynchronous command
CURSor<m>:AOFF
This command switches all cursors off.
Suffix:
<m>
.
The numeric suffix is irrelevant.
Cursor measurements