Rohde & Schwarz RTP Series - D-PHY (Option R&S RTP-K42)

Remote control commands
R&S
®
RTP
1842User Manual 1337.9952.02 ─ 12
SEARch:RESult:RFFE:SEQuence<m>:BYTE<n>:STATe? <SearchName>
Suffix:
<m>
.
*
<n> *
Query parameters:
<SearchName>
Return values:
<ByteState> OK | PARity
OK: the byte is valid.
PARity: parity error
*RST: OK
Usage: Query only
SEARch:RESult:RFFE:SEQuence<m>:BYTE<n>:VALue?
<SearchName>
Suffix:
<m>
.
*
<n> *
Query parameters:
<SearchName>
Return values:
<ByteValue> Range: 0 to 255
Increment: 1
*RST: 0
Usage: Query only
22.17.14 D-PHY (Option R&S RTP-K42)
● D-PHY configuration........................................................................................... 1842
● D-PHY trigger......................................................................................................1848
● D-PHY decode results.........................................................................................1855
● D-PHY search settings........................................................................................1861
● D-PHY search results..........................................................................................1869
22.17.14.1 D-PHY configuration
BUS<m>:DPHY:CONFig...............................................................................................1843
BUS<m>:DPHY:CP:PROBe.......................................................................................... 1843
BUS<m>:DPHY:CP:SOURce........................................................................................ 1844
BUS<m>:DPHY:DRATe................................................................................................ 1844
BUS<m>:DPHY:DSPData.............................................................................................1844
BUS<m>:DPHY:THCoupling......................................................................................... 1845
Protocols