Rohde & Schwarz RTP Series - Waveform Histogram Export to File

Remote control commands
R&S
®
RTP
1535User Manual 1337.9952.02 ─ 12
EXPort:WAVeform:FASTexport <Enable>
To improve the performance of data export to file, the measurements are performed
slower while the data export speeds up.
Setting parameters:
<Enable> ON | OFF
Example: See Chapter 22.3.5.2, "Exporting waveform data to file",
on page 1133
Usage: Setting only
Asynchronous command
22.16.6 Waveform histogram export to file
EXPort:HISTogram:SELect............................................................................................1535
EXPort:HISTogram:INCidence.......................................................................................1535
EXPort:HISTogram:NAME.............................................................................................1535
EXPort:HISTogram:SAVE..............................................................................................1536
EXPort:HISTogram:DATA?............................................................................................1536
EXPort:HISTogram:SELect <Name>
Selects the histogram to be exported.
Parameters:
<Name> String with the histogram name.
Example: See "Exporting histogram data to file" on page 1130
Usage: Asynchronous command
EXPort:HISTogram:INCidence <Incidence>
Sets the mode of exported data: relative or absolute frequency of amplitude values.
Parameters:
<Incidence> ABS | REL
*RST: REL
Example: See "Exporting histogram data to file" on page 1130
Usage: Asynchronous command
EXPort:HISTogram:NAME <Path>
Sets the file name and path to save the histogram to.
Parameters:
<Path> String with path and file name. The file extension defines the file
format: XML, CSV, or BIN.
Data management