Acquisition and waveform setup
R&S
®
RTP
182User Manual 1337.9952.02 ─ 12
Measurement
Shows the measured common mode voltage.
Remote command:
PROBe<m>:SETup:TERM:MEASure? on page 1220
5.6.6 Setup for predefined probes
Probes that cannot be detected, but their characteristics are known to the R&S RTP
are called "Predefined probes".
The following shared probe settings are available:
●
"Type, Name, Bandwidth" on page 166
●
"Detect AutoZero, Use AutoZero" on page 166
The probe attenuation of the selected probe is also shown in the "Probes" tab:
●
"Probe unit, Auto attenuation" on page 168
Figure 5-12: Probe setup for transmission line probe R&S
RT-ZZ80
Probes
To Next Page
Loading...
