Rohde & Schwarz RTP Series - Status Reporting

Remote control commands
R&S
®
RTP
2305User Manual 1337.9952.02 ─ 12
CALibration:RESult?
Returns the result of the last selfalignment and the current alignment status. In remote
mode, *CAL? provides more detailed information.
Return values:
<ResultState> PASSed | FAILed | NOALigndata
*RST: FAILed
Usage: Query only
Asynchronous command
DIAGnostic:SERVice:STST:EXECute
Starts the selftest.
Usage:
Event
Asynchronous command
DIAGnostic:SERVice:STST:STATe?
Returns the summary result of the selftest.
Return values:
<State> PSSD | FAILed | UNDefined
*RST: UNDefined
Usage: Query only
Asynchronous command
DIAGnostic:SERVice:PWD <Password>
Sets the password to enter the service mode.
Setting parameters:
<Password> Password string
Usage: Setting only
22.25 Status reporting
This chapter describes the remote commands that are used to read the status regis-
ters.
For information on structure, hierarchy, and contents of the status registers, see Chap-
ter 21.5.4, "Remote control - status reporting system", on page 1109.
● STATus:OPERation register................................................................................2306
● STATus:QUEStionable registers......................................................................... 2306
Status reporting