Instrument setup
R&S
®
RTP
126User Manual 1337.9952.02 ─ 12
4.7.4 Maintenance information
Access: "Settings" >"Maintenance" > "Hardware" tab > "Advanced"
The "Maintenance" dialog box provides information on your R&S RTP configuration,
which can be helpful in case you need support.
System Info
This tab provides general information on the hardware configuration, and indicates
where system information can be found on the instrument. Here you can also show the
content of the device footprint file.
Remote command:
DIAGnostic:SERVice:PARTnumber on page 1186
DIAGnostic:SERVice:SERialnumber? on page 1186
SYSTem:DFPRint on page 1185
Mainboard
This tab provides information on the mainboard configuration in your instrument.
Frontend
This tab provides information on the frontend configuration in your instrument.
Frontpanel
This tab provides information on the front panel module installed in your instrument.
MSO
This tab is only relevant if the MSO option R&S RTP-B1 is installed. The tab provides
information on the MSO hardware module that is installed in your instrument.
AWG
This tab is only relevant if the waveform generator option R&S RTP-B6 is installed. The
tab provides information on the generator hardware module that is installed in your
instrument.
PSC
This tab is only relevant if the pulse source option R&S RTP-B7 is installed. The tab
provides information on the pulse source hardware module that is installed in your
instrument.
Service
This tab allows the service personnel to enter a password that activates further service
functions.
Remote command:
●
DIAGnostic:SERVice:PWD on page 2305
Maintenance settings
To Next Page
Loading...
