Waveform generator (Option R&S RTP-B6)
R&S
®
RTP
968User Manual 1337.9952.02 ─ 12
Start frequency
Sets the start frequency of the sweep signal.
Remote command:
WGENerator<m>:SWEep:FSTart on page 2229
Stop freuqency
Sets the stop frequency of the sweep signal.
Remote command:
WGENerator<m>:SWEep[:FEND] on page 2229
Sweep time
Sets the duration of the sweep.
Remote command:
WGENerator<m>:SWEep:TIME on page 2229
15.1.5 Arbitrary
The arbitrary waveform generator allows you to output a user-defined waveform for
testing your devices. You can output a waveform from a file or from the current
R&S RTP reference curve format. Files in *.csv and *.bin formats are supported.
This files must follow a defined structure. You can load *.csv files in an R&S Wave
Setup of the waveform generator
To Next Page
Loading...
